The "ULTIMATE" REMOTE CONTROL, LCD SIGN AND AUTOMATION INTERFACE FOR THE SAGE-ENDEC MODELS SE1822 and 3644 DIGITAL E.A.S. ENCODER/DECODER

Remote Control

The “Ultimate” EAS remote Control and Automation Interface for the Sage-Endec SE1822 and 3644 Digital E.A.S. encoder/decoder. This little beauty has all the features you could ask for.

• Large BACKLIT LCD SCROLLING DISPLAY showing date, time, and alert details, just like the LED sign display, with a small footprint for crowded countertops

• ATTENTION GETTING STROBE to catch your eye when an alert is pending, and the color is tailored to the severity of the alert

• Ability to PREVIEW THE PENDING ALERT AUDIO through an internal speaker or earphones, and an independent rear panel line output is supplied

• Dedicated push buttons to INITIATE RWT, RELAY PENDING ALERT OR RMT, KILL PENDING ALERT, REVIEW PENDING ALERT AUDIO, CLEAR STROBE AND CLEAR SIGN

• No menus to sort through (Note: Individual station control is not supported when the Endec is used in multistation mode)

Interface Module

• AUTOMATION INTERFACE that will allow contact closures from your automation to initiate an RWT or relay a pending alert, and WITH RELAY OUTPUTS to notify your automation of the presence of a pending alert (momentary or continuous, user selectable) and a momentary closure to notify your automation at the end of the relayed message.

• 2 software versions available.
1- Single button push for RWT and Pending Alert release. Endec relays RWT or Pending Alert 5-7 seconds after button push. This is due to Endec decoding time. (Version 1.4 & 2.0)
2- Double button push for RWT and Pending Alert release. First button push loads information into Endec. Second button push relays alert immediately. LED flashes showing "ready to relay" status. (Version 1.5 & 2.1)

....only $439.00 + shipping (Please specify software version when ordering)

Specifications:

Case Dimensions: 8.4" wide X 4.3" deep X 1.2" high
Case Material and Color: plastic, light grey
LCD Display Dimensions: 6 1/16 X 5/8
Character Size: .453 X .265
LCD Display: Yellow Backlight
CUE Speaker (internal) and Earphone output: .2 W, variable gain with off switch
Earphone Jack: 1/4" Stereo (wired for mono), disconnects CUE speaker
Line Output: Unbalanced 600 ohms, 3.5mm mono jack on rear panel
Connection Method: 50' Category 5e cable with RJ45 connectors, supplied
DB9 interface modules with automation control screw terminal interface connections
Sage-Endec Interface: Serial RS 232, 2 Endec ports required
Power: External power supply (supplied), Input - 120VAC 50-60Hz, Output: 9VDC @ 500 ma
Power Cord Length: approximately 6ft. total
Mounting: Desktop
Operating temperature: 32 to 120F
Humidity: 0 to 95% non-condensing
Shipping Weight: approximately 4 lbs.
(Sage Endec is a trademark of Sage Alerting Systems)

Click Here For User Guide for software version 1.4
Click Here For User Guide for software version 1.5