 |
|
|
The
Pager-Dialer system that will notify you anytime you want to be called
or paged when events take place! The Pager-Dialer gives the user a programmable
telephone dialer with tone encoding for audible telephone messaging and/or
pager activation output. There are 2 input ports requiring only a contact
closure to initiate the functions. This device may be programmed by your
PC using HyperTerminal, or may be ordered pre-programmed at no additional
cost. The Pager-Dialer will accept 2 phone or pager numbers to be dialed,
one for each port, and specific user programmable display or audible codes
for each port for your pager or telephone. The dialer may be "daisy
chained" by use of accessible jumper settings to automatically dial
one complete sequence after the other if desired. The numbers dialed and
codes transmitted may be different for each port, or the same, depending
on how the Pager-Dialer is programmed. Programming is non-volatile and
will remain in memory until re-programmed. Battery back-up is included
in the Pager-Dialer.
Only $183.00 + shipping
Integrated
Power Up or Power Down Detector add $39.00
Both for $55.00!
Pager-DialerSpecifications:
Telephone Connection: Modular RJ-11
Power Requirements: Wall adapter, 115 VAC to 9-12 VDC, 100-200 ma. (supplied)
Battery Back-up Requirements: 9 VDC alkaline battery, NEDA 1604A (supplied)
Size: 5.1 x 5.3 x 1.7
Serial Connection for Programming: DB-9 (M-F 6' cable supplied)
Memory: 2 Telephone numbers and 2 code sequences, 15 digits each in length,
non-volatile
Allowed Characters: 0-9, *, #, and W (a W will insert a 2.5 sec. delay
between characters)
Inputs: Screw terminals; common, alert 1 & alert 2.
Dialing initiation: Contact closure from common to either input, momentary
or continuous
Shipping Weight: Approximately 2 lbs.